OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P06E5

Glow Plug Control Module 1 Performance

P06E5 means glow plug control module 1 does not respond correctly to the glow command: its outputs do not switch or its internal drivers report faults or overheating. Ford's 2023 6.7 L and 3.0 L Power Stroke list P06E5 among the glow module checks, run continuously, with a fault after about 1 s when internal drivers for glow plugs, DEF heaters or relays fail to switch or overheat for more than 1 s – Ford does not assign each threshold to a single code. GM files the same check under P064C: on the L5P a plug commanded on but drawing under 3.2 A with 0 V at the plug for 3.5 s, on the LML a total current under 6.6 A; both after two trips. The plugs then heat partly or not at all, with hard cold starts and white smoke. There is no limp mode.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / E5

Possible causes

  • Glow plug control module faulty internally (drivers do not switch) high
  • Poor supply or ground of the module (main feed, fuse, ground) medium
  • Module overheating (mounting location, short at a plug) medium
  • Module software low

Symptoms

  • Check engine light, possibly glow plug/wait-to-start lamp
  • Hard cold start, long cranking
  • White smoke and rough running after cold start
  • Often stored together with plug codes or P064C/P263C

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P06E5

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication