OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P06E3

Cylinder 12 Glow Plug Control Circuit High

Diesel glow systems switch each plug through its own power semiconductor and switch off a faulty channel; CARB requires single-plug detection from model year 2010. P06E3 means the circuit to the cylinder 12 glow plug is shorted to positive: voltage is present although the driver is off, or no current flows when it is on. For cylinders 1–8, GM's engine-module drivers flag a short to positive below 0.5 Ω after two trips, and Ford's 2023 Power Stroke 0 A while commanded for about 1 s. The plug may glow permanently and fail early; the other plugs keep working. Wiring shorted to supply or a failed driver are the usual causes. No manufacturer document available to us uses this code – it needs at least 12 cylinders, and the only US OBD II diesel above eight, VW's Touareg V10 TDI, has ten; the description follows cylinders 1–8.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / E3

Possible causes

  • Plug wire shorted to supply in the harness high
  • Driver stage in the glow module shorted (permanently on) medium
  • Moisture or corrosion bridging to a supply pin medium
  • Glow module software low

Symptoms

  • Check engine light (GM: also glow plug lamp)
  • Harder cold start in frost
  • Rough cold idle, white smoke after cold start
  • Plug may glow permanently and fail early

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P06E3

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication