P06E1
Cylinder 11 Glow Plug Control Circuit High
Diesel glow systems switch each plug through its own power semiconductor and switch off a faulty channel; CARB requires single-plug detection from model year 2010. P06E1 means the circuit to the cylinder 11 glow plug is shorted to positive: voltage is present although the driver is off, or no current flows when it is on. For cylinders 1–8, GM's engine-module drivers flag a short to positive below 0.5 Ω after two trips, and Ford's 2023 Power Stroke 0 A while commanded for about 1 s. The plug may glow permanently and fail early; the other plugs keep working. Wiring shorted to supply or a failed driver are the usual causes. No manufacturer document available to us uses this code – it needs at least 11 cylinders, and the only US OBD II diesel above eight, VW's Touareg V10 TDI, has ten; the description follows cylinders 1–8.
Possible causes
- Plug wire shorted to supply in the harness high
- Driver stage in the glow module shorted (permanently on) medium
- Moisture or corrosion bridging to a supply pin medium
- Glow module software low
Symptoms
- Check engine light (GM: also glow plug lamp)
- Harder cold start in frost
- Rough cold idle, white smoke after cold start
- Plug may glow permanently and fail early
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P06E1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.