OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P06DF

Glow Plug Control Module 1 Memory Checksum Error

A diesel glow plug control module has its own microcontroller. On power-up it forms a checksum over its memory and compares it with the stored value; P06DF means they differ, so the module's program or data cannot be trusted. Ford's 2023 6.7 L and 3.0 L Power Stroke list P06DF among the glow module checks, run at power-up and flagged on a RAM checksum mismatch after about 1 s. GM's L5P performs the same check on ROM (4.5 s, two trips) but reports it as P064C. CARB treats the module as a 'smart device' whose internal faults need not be pinpointed, so this is extra diagnosis by the manufacturer. The usual remedy is reprogramming or replacing the module; until then preheating may be missing.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / DF

Possible causes

  • Glow plug control module faulty internally (memory, controller) high
  • Failed or interrupted programming of the module medium
  • Voltage dip or spike at power-up (weak battery, poor ground) low
  • Moisture or corrosion in module or connector low

Symptoms

  • Check engine light, possibly glow plug/wait-to-start lamp
  • Hard cold start, long cranking
  • White smoke and knocking after cold start
  • Often no symptoms when warm

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P06DF

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication