OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P06DE

Engine Oil Pressure Control Circuit Stuck On

A switchable oil pump changes its output via a solenoid valve; powered it runs at the low stage. To test it, the module switches the pump between stages (GM up to 15 times, with oil at 50–110 °C and 1350–2500 rpm, expecting more than 100 kPa difference) and watches the oil pressure sensor; Ford checks each switch-over of a two-stage pump within 1 s, or a variable pump over 10 s, from 30 s after start. P06DE is the counterpart of P06DD: the commanded high stage is not reached and the pressure stays below the threshold, as if the valve were stuck on. Too little oil pressure at high load endangers the engine, so GM sets it after just one trip; a Ford patent raises idle speed in this case. A short to ground on the control wire (P06DB) has the same effect electrically. An FCA bulletin for the 3.6 L V6 fixes false codes by software.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / DE

Possible causes

  • Control valve stuck in the powered position high
  • Low oil level, diluted or sludged oil, aeration medium
  • Pump wear or internal leakage medium
  • Engine module software (FCA 3.6 L) low
  • Oil pressure sensor low

Symptoms

  • Check engine light at once
  • Oil pressure warning at higher engine speed possible
  • Possibly reduced power or raised idle
  • Valvetrain or chain tensioner noise from lack of oil

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P06DE

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication