OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P06DD

Engine Oil Pressure Control Circuit Performance/Stuck Off

A switchable oil pump changes its output via a solenoid valve; unpowered it delivers high pressure. To test it, the module switches the pump between stages (GM up to 15 times, with oil at 50–110 °C and 1350–2500 rpm, expecting more than 100 kPa difference) and watches the oil pressure sensor; Ford checks each switch-over of a two-stage pump within 1 s, or a variable pump over 10 s, from 30 s after start. P06DD means the pressure does not react and stays above the threshold – the pump acts as if the valve were stuck off, at high pressure; GM sets it after two trips. Yet GM bulletins for V8 and 2.5 L engines list P06DD with low oil pressure, too: broken valve tips, unseated valves, a loose pump drive gear or worn tensioners also stop the pressure from changing. Check oil level and pressure before replacing parts.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / DD

Possible causes

  • Control valve stuck or broken, screen clogged high
  • Oil level too low, wrong viscosity or sludge medium
  • Mechanical pump or drive damage (tensioner, drive gear, pump face) medium
  • Valve not seated correctly (retaining clip) low
  • Oil pressure sensor inaccurate low

Symptoms

  • Check engine light after two trips
  • Oil pressure stays high – or, with pump damage, low or fluctuating
  • Possibly oil pressure warning
  • Slightly higher fuel consumption

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P06DD

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication