P06D4
Sensor Reference Voltage E Circuit High
The engine module feeds sensors from several regulated 5 V reference circuits; a short at one sensor pulls the whole circuit down and all its sensors report at once – unplug them one by one to find the culprit. P06D4 means reference E is too high – often a sensor signal wire shorted to 12 V. No manufacturer document available to us names P06D4 itself; Ram's 6.7 L Cummins uses the neighbouring P06D3, and GM reports circuit E under P06D2. Sensors on the circuit then read too high.
Possible causes
- Reference or sensor signal wire shorted to 12 V high
- Chafing or water in harness or connector medium
- A connected sensor faulty internally medium
- Module internal voltage regulator or components low
Symptoms
- Check engine light
- Several sensor codes at once
- Reduced power or limp mode
- Possibly starting problems
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P06D4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.