P06CE
Cylinder 10 Glow Plug Incorrect
A glow plug has no identification; the control unit recognises its type only from its electrical behaviour – cold resistance at switch-on and how resistance rises during heating (R = U/I). A Beru patent describes how steel and ceramic plugs are told apart this way so the right heating profile is used and a wrong or mixed type is reported. A low-voltage plug on an 11 V control burns out, an 11 V plug on a low-voltage control glows too weakly. GM uses 'incorrect' for any resistance outside the window: the 2025 diesels check 0.22–2.00 Ω (15 of 25 samples, two trips), the L5P glow module a ramp-dependent window. P06CE reports this for cylinder 10. No manufacturer document available to us uses this code for cylinders 9 and above; the description follows cylinders 1–8.
Possible causes
- Wrong glow plug type fitted in cylinder 10 (steel/ceramic, voltage rating) high
- Plug resistance drifted (ageing, damage) medium
- Glow module software or check during cranking (false report) medium
- Contact resistance at the plug connector low
Symptoms
- Check engine and glow plug lamp
- Harder cold start or white smoke
- Possibly plug burnt out (low-voltage plug on 11 V control)
- Code after replacing plugs
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P06CE
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.