OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P06BA

Cylinder 2 Glow Plug Circuit Range/Performance

The glow module calculates each plug's resistance from voltage and current while glowing. 'Range/performance' means the circuit is electrically intact but the resistance or current lies outside the specified window – typically an aged, high-resistance or wrong plug or contact resistance at the connector. CARB requires a single plug outside specification to be detected from model year 2010. Ford's 2023 6.7 L/3.0 L Power Stroke runs this check during heating after the open and short checks and flags a circuit above 2 Ω after about 3 s. GM does not use this code family. Ram's 6.7 L Cummins (from model year 2025, with glow plugs instead of the grid heater) set these codes falsely; the fix was reprogramming the engine module. On the 2014–15 Ram ProMaster 3.0 L diesel, plugs without an inner O-ring caused it; all plugs were replaced. P06BA concerns the glow plug of cylinder 2 alone; the same plug's open circuit is P0672, its control circuit low and high P066C/P066D, and an incorrect plug fitted P06C6.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / BA

Possible causes

  • Glow plug cylinder 2 aged or high-resistance high
  • Contact resistance at plug connector or terminal nut medium
  • Wrong plug type or a plug with a manufacturing fault medium
  • Engine or glow module software (Ram 6.7 L from 2025) low

Symptoms

  • Check engine and glow plug lamp
  • Harder cold start in frost
  • Rough running and white smoke after a cold start
  • Often no symptom when warm

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P06BA

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication