P06B2
Sensor Power Supply A Circuit High
Despite the similar name, 'sensor power supply' is not the 5 V sensor reference (P0641 ff). It is documented in GM hybrid drive motor control modules: a 15 V supply that excites the motor position sensor (resolver) and powers the gate drivers of the inverter transistors, kept separate from the 5 V reference and the 12 V supply. In GM's 2008 Two-Mode hybrid, A and B are the two motor control modules. P06B2 means supply A is too high: GM's 2008 Two-Mode hybrid flags above 18.0 V for 1042 ms, a 2016 GM hybrid control module above 18.6 V in 40 of 50 samples, each after two trips. Typical causes are a faulty internal regulator or overvoltage in the 12 V system. Mitsubishi's 2022 Outlander lists it as a sub-code.
Possible causes
- Internal supply regulator of the motor control module faulty high
- Overvoltage in the 12 V system (DC/DC converter, charging) medium
- Supply wire shorted to a higher voltage medium
- Connector or wiring fault low
Symptoms
- Check engine or hybrid warning light
- Electric drive or hybrid mode limited or disabled
- Further motor position or inverter codes
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P06B2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.