P06AF
Torque Management System Forced Engine Shutdown
GM uses P06AF for a cross-check between two control modules: the monitored module (engine or transmission module, each with main and secondary processor) sends a fixed answer sequence over CAN only if both its processors work together correctly; the monitoring module (engine, transmission or hybrid control module) sets P06AF if the pattern is wrong or missing. In all GM tables from 2016 to 2025 it is type A – lamp in the first trip – and the torque management may shut the engine down for safety. Typical causes are processor or software faults in one of the modules, communication problems or supply interruptions. Look for further processor codes (P0606, P060A, P060B) and software bulletins. No other manufacturer document available to us uses P06AF.
Possible causes
- Software fault in engine, transmission or hybrid module high
- Processor fault in one of the modules medium
- CAN communication disturbance between the modules medium
- Supply interruption or poor ground of a module low
Symptoms
- Check engine light
- Engine shuts off or does not start
- Reduced power
- Further processor or communication codes
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P06AF
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.