P06A4
Sensor Reference Voltage D Circuit Low
The engine module feeds sensors from several regulated 5 V reference circuits; a short at one sensor pulls the whole circuit down, so all its sensors report at once – unplug them one by one to find the culprit. On GM engines (2016–2025) circuit D feeds pedal sensor 1 and both throttle position sensors, on the Saab 9-4X the throttle and pedal sensor 1 – a fault therefore usually means electronic throttle limp mode. P06A4 means reference D is too low – a short to ground or overload. No manufacturer document available to us uses P06A4 itself: GM and Saab report circuit D faults collectively as P06A3. The description follows circuits A–C.
Possible causes
- Short in the wire or sensor of a connected sensor high
- Chafing or water in harness or connector medium
- A connected sensor faulty internally medium
- Module internal voltage regulator low
Symptoms
- Check engine light
- Several sensor codes at once (pedal, throttle, pressure)
- Electronic throttle limp mode, reduced power
- Possibly starting problems
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P06A4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.