P06A0
Variable A/C Compressor Control Circuit
Variable-displacement A/C compressors change their swash-plate stroke via an electric control valve: a PWM current sets the crankcase pressure and thus the output. Where the engine module drives this valve (Ford's 'EVDC' compressors 2013–2019), it monitors the circuit; where the climate control module drives it (Hyundai, VW/Audi, GM), faults appear in that module instead. CARB requires monitoring only where the A/C affects engine control. P06A0 is the general circuit fault of the compressor control valve. Ford's service messages for its EVDC compressors (2013–2019) describe it with weak or no cooling, typically from a valve with an open coil or a corroded connector at the compressor; low refrigerant can also mislead the diagnosis. The compressor then runs at minimum stroke or does not cool. Not emission relevant in most cases.
Possible causes
- Compressor control valve faulty (coil open) high
- Connector at the compressor corroded or loose, wire open high
- Low or incorrect refrigerant charge misleading the diagnosis medium
- Engine module driver faulty low
Symptoms
- A/C cools weakly or not at all
- Code stored, check engine light usually off
- Compressor stays at minimum output
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P06A0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.