P069F
Throttle Actuator Control Lamp Control Circuit
P069F concerns the hard-wired control circuit of the electronic throttle warning lamp (called 'reduced power', wrench or EPC lamp depending on the maker), which lights when the throttle control detects a fault and limits power. The module monitors this output electrically for open circuit and shorts; it cannot see whether the lamp lights. No manufacturer document available to us uses P069F – Ford, for example, switches its wrench lamp via the instrument cluster over the bus, not on its own wire. CARB requires output circuits to be monitored. Without a working lamp the driver is not warned when the engine enters throttle limp mode. The MIL circuit is P0650.
Possible causes
- Open or short in the lamp wire between engine module and cluster high
- Lamp/LED or its driver in the instrument cluster faulty medium
- Connector at cluster or module corroded or loose medium
- Engine module driver faulty low
Symptoms
- Throttle warning lamp does not light at bulb check, or stays on
- No warning when the engine goes into throttle limp mode
- Code stored, engine runs normally
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P069F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.