OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P069D

Cylinder 10 Glow Plug Control Circuit High

Modern diesel glow systems switch each glow plug through its own power semiconductor (in a glow plug module or the engine module), so current and faults can be measured per plug; a faulty channel is switched off. CARB requires glow plugs to be checked for correct current and voltage drop and, since model year 2010, a single plug outside specification to be detected and named. P069D means the circuit to the cylinder 10 glow plug is shorted to battery voltage, so the driver cannot switch it off. GM's engine-module drivers detect an impedance to the supply below 0.5 Ω (0.14 Ω for low-resistance plugs) in 10 of 20 samples, lamps after two trips; Ford's 2023 Power Stroke sees 0 A in its measuring path while the plug is commanded on. A permanently powered plug can overheat and burn through. No manufacturer document available to us uses this code for cylinders 9 and above; the description follows cylinders 1–8.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 9D

Possible causes

  • Cylinder 10 plug wire touching battery positive (chafing in the harness) high
  • Moisture or corrosion in the module or plug connector medium
  • Driver in the glow or engine module shorted (permanently on) medium
  • Glow module software (GM bulletins) low

Symptoms

  • Check engine and glow plug lamp
  • Plug permanently powered, possible battery drain
  • Plug burns through, then an open-circuit code

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P069D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication