OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0697

Sensor Reference Voltage C Circuit/Open

The engine module feeds sensors from several regulated 5 V reference circuits; a short at one sensor pulls the whole circuit down, so all its sensors report at once – unplug them one by one to find the culprit. Which sensors hang on circuit C depends on the maker – pedal sensor 2 is common to all: GM 2016–2025 feeds only pedal sensor 2 from it, the Saab 9-4X also the MAP sensor, the Saab 9-5 2.0 L turbo also throttle, crankshaft and A/C pressure sensors, and Bentley's 2026 Bentayga V8 lists its own set. P0697 is the general code for circuit C. GM puts all faults into it: reference outside 4.875–5.125 V or jumping, 19 of 39 counts or 0.19 s, lamp in the first trip; GM Europe's 2.0 L turbo also uses P0698/P0699.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 97

Possible causes

  • Short in the wire or sensor of a connected sensor high
  • Chafing or water in harness or connector medium
  • A connected sensor faulty internally medium
  • Module internal voltage regulator low

Symptoms

  • Check engine light
  • Several sensor codes at once (pedal, throttle, pressure)
  • Electronic throttle limp mode, reduced power
  • Possibly starting problems

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0697

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication