OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P068C

Cylinder 7 Glow Plug Control Circuit Low

Modern diesel glow systems switch each glow plug through its own power semiconductor (in a glow plug module or the engine module), so current and faults can be measured per plug; a faulty channel is switched off. CARB requires glow plugs to be checked for correct current and voltage drop and, since model year 2010, a single plug outside specification to be detected and named. P068C means the circuit to the cylinder 7 glow plug is shorted to ground or draws overcurrent. GM's engine-module drivers flag an impedance to ground below 0.11 Ω (10 of 20 samples) with the check engine and glow plug lamps after two trips; Ford's 2023 Power Stroke checks during heating for more than 22 A for 0.3 s or 20–22 A for 2 s. The channel is switched off and plug 7 no longer heats – harder cold starts and white smoke follow.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 8C

Possible causes

  • Glow plug cylinder 7 shorted internally (element against body) high
  • Plug wire insulation damaged and shorted to ground medium
  • Wrong plug type (resistance or voltage rating) low
  • Driver in the glow or engine module faulty, or software (GM bulletins) low

Symptoms

  • Check engine and glow plug lamp
  • Harder cold start, especially in frost
  • Rough running and white smoke right after a cold start

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P068C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication