OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P068B

ECM/PCM Power Relay De-Energized Performance Too Late

The engine module switches its main relay coil to ground (control circuit), reads the switched voltage back on a sense line and keeps the relay on briefly after ignition off to save learned values. P068B is the counterpart of P068A: after ignition off and the module's switch-off command the relay voltage remains – the relay drops out late or not at all. GM Europe's 2.0 diesel runs this check from ignition off until the module shuts down and names a control line shorted to ground (coil stays energised), an output line shorted to voltage or a sticking contact as causes, without lighting the MIL. Modules and loads then stay powered and the battery drains. GM reports the same electrical faults as P0686/P0690 instead. A Ford diesel table lists 'P068B' for a memory error, which is evidently a typo for P06B8.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 8B

Possible causes

  • Relay contact sticking or welded high
  • Relay control wire shorted to ground (coil stays energised) medium
  • Relay output or load line shorted to voltage medium
  • Module driver or software low

Symptoms

  • Relay or module stays active after ignition off (fan or pump keeps running)
  • Battery drains
  • Possibly check engine light (depending on the maker)

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P068B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication