P0687
ECM/PCM Power Relay Control Circuit High
The engine module switches its main relay coil to ground (control circuit), reads the switched voltage back on a sense line and keeps the relay on briefly after ignition off to save learned values. P0687 means the control line is shorted to voltage: when the driver switches on and should pull it to ground, it stays high (0.5 Ω or less to positive) or the driver goes into overcurrent protection, so the relay does not pull in – no supply to the loads, no start or stalling. GM checks with run/crank voltage above 11 V and sets the code after 8 of 10 samples at 250 ms, with the lamp after two trips. The former obdex title (a sense-circuit wording) was a shifted entry; P0687 is the 'high' code of the control circuit. A high voltage on the sense line is P0690.
Possible causes
- Control wire shorted to positive (harness, external voltage) high
- Relay coil shorted (very low resistance) medium
- Module driver faulty low
Symptoms
- Check engine light
- Engine does not start or stalls
- Relay does not click
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0687
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- gsi.ext.gm.com/gmspo/mode6/pdf/2025/25OBDG03A.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2019/19OBDG03B Diagnostics.pdf
- saabwisonline.com/9-5-9650/2010/2-engine/engine-management-and-fuel-system-v6/fault-diagnosis-diagnostic-trouble-codes/dtc-p0685-p0686-p0687-p0689-or-p0690