P0682
Cylinder 12 Glow Plug Circuit/Open
Modern diesel glow systems switch each glow plug through its own power semiconductor (in a glow plug module or the engine module), so current and faults can be measured per plug. CARB requires glow plugs to be checked for current and voltage drop and, since model year 2010, a single faulty plug to be detected and named. P0682 means the load circuit of the cylinder 12 glow plug is open while glowing. No manufacturer document available to us uses this code – the only diesel with more than eight cylinders sold under OBD II in the US, VW's Touareg V10 TDI (2006–07) with ten cylinders, is documented only with a general glow plug tip naming no codes. The description therefore follows cylinders 1–8 (GM 200 kΩ, Ford below 1 A). A weak battery strains the glow system on such engines.
Possible causes
- Glow plug cylinder 12 burnt out (element open) high
- Plug connector loose or corroded, terminal nut loose, wire broken medium
- Glow module supply or ground (several cylinder codes at once) medium
- Glow module or driver faulty, or software (GM bulletins) low
Symptoms
- Check engine light (GM also glow plug lamp)
- Harder cold start in low temperatures
- Rough idle and white smoke after a cold start
- Often no symptoms when warm
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0682
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.