Powertrain
generic / SAE
P0680
Cylinder 10 Glow Plug Circuit Open
The glow plug circuit on cylinder 10 is open - usually a broken connection or burnt-out heater element.
SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 80
Possible causes
- Plug element burnt out high
- Pin pushed back out of connector body low
- Cracked solder joint inside the module or sensor low
Symptoms
- Glow plug warning light on (often orange coil symbol)
- Hard cold start or no start in cold weather
- White smoke from exhaust during warm-up
Inspection / repair
- Difficulty: easy
- DIY: possible
- Estimated cost: 60–250 €
- Estimated time: 0.4–1.4 h
- Component: glow plug cyl 10
- MIL / check engine light
- emissions-relevant
Sources
References
sae:J2012