OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0672

Cylinder 2 Glow Plug Circuit/Open

Modern diesel glow systems switch each glow plug through its own power semiconductor (in a glow plug module or the engine module), so current and faults can be measured per plug; a faulty channel is switched off. CARB requires glow plugs to be checked for correct current and voltage drop and, since model year 2010, a single plug outside specification to be detected and named. P0672 means the load circuit of the cylinder 2 glow plug is open while glowing. Thresholds: GM engine-module drivers 200 kΩ or more (two trips), GM's L5P glow module less than 4.0 A at over 6 V, Ford's 2023 Power Stroke less than 1 A for about 1 s. Older GM systems (LB7/LLY, LML) report open and short under this one code. Chrysler advises checking the main B+ feed and ground of the glow module first when several cylinder codes appear together.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 72

Possible causes

  • Glow plug cylinder 2 burnt out (element open) high
  • Plug connector loose or corroded, terminal nut loose, wire broken medium
  • Glow module supply or ground (several cylinder codes at once) medium
  • Glow module or driver faulty, or software (GM 3.0 L 2020) low

Symptoms

  • Check engine light (GM also glow plug lamp)
  • Harder cold start in low temperatures
  • Rough idle, knocking and white or blue smoke after a cold start
  • Often no symptoms when warm

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0672

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication