OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P066F

Cylinder 3 Glow Plug Control Circuit High

Modern diesel glow systems switch each glow plug through its own power semiconductor (in a glow plug module or the engine module), so current and faults can be measured per plug; a faulty channel is switched off. CARB requires glow plugs to be checked for correct current and voltage drop and, since model year 2010, a single plug outside specification to be detected and named. P066F means the circuit to the cylinder 3 glow plug is shorted to battery voltage, so the driver cannot switch it off. GM's engine-module drivers detect an impedance to the supply below 0.5 Ω (0.14 Ω for low-resistance plugs) in 10 of 20 samples, with the lamps after two trips; Ford's 2023 Power Stroke sees 0 A through its measuring path while the plug is commanded on (about 1 s). A permanently powered low-voltage plug can overheat and burn through, after which an open-circuit code follows, and the battery may drain.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 6F

Possible causes

  • Cylinder 3 plug wire touching battery positive (chafing in the harness) high
  • Moisture or corrosion in the module or plug connector (leakage between pins) medium
  • Driver in the glow or engine module shorted (permanently on) medium
  • Glow module software (GM 3.0 L 2020) low

Symptoms

  • Check engine and glow plug lamp
  • Plug permanently powered, possible battery drain
  • Plug burns through, then an open-circuit code
  • Often no symptom when warm

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P066F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication