OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0667

Control Module Internal Temperature Sensor A Range/Performance

Control modules measure their own circuit board temperature with an internal sensor to protect output stages (overtemperature is P0634) and, in GM transmission modules, as a substitute for fluid temperature. In GM's 6T70/6T75 and related automatics the sensor sits in the transmission module inside the valve body, with no external wiring – so the repair is practically always the module or valve body assembly. P0667 is the plausibility check: GM compares the module (substrate) temperature with the transmission fluid temperature and the temperature measured at power-up. The Saab 9-4X sets it when, within 5 of 6 minutes, fluid and substrate differ by more than 20–50 °C and power-up and substrate by more than 8–10 °C (two trips); GM's 2019 table uses 3000 of 3750 samples. The module then uses the power-up temperature instead. Check the fluid temperature sensor (P0711) first – it is the comparison partner.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 67

Possible causes

  • Transmission module or valve body (internal sensor) faulty high
  • Transmission fluid temperature sensor reads wrong (comparison partner) medium
  • Unusual conditions (long standing in extreme cold or heat, fluid level or condition) low

Symptoms

  • Engine or transmission warning lamp
  • Harsher or delayed shifts (substitute temperature)
  • Possibly P0711 as well

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0667

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication