P0665
Intake Manifold Tuning Valve Control Circuit High Bank 2
The intake manifold tuning valve switches the manifold length or plenum connection with engine speed (more torque low, more power high); it is not the runner or swirl flap (IMRC, P2004 ff). P0665 means the bank 2 control line stays high with the driver on – a short to voltage or overcurrent, after which the driver shuts off. Bank 2 codes require a V-engine manifold with two separately switched valves; many V engines use a single central valve between the plenums, and no manufacturer document available to us uses this code, so the description follows bank 1. At GM the bank 1 equivalent (P0662) flags 0.5 Ω or less to positive in 40 of 50 samples, with the lamp after two trips.
Possible causes
- Bank 2 control wire shorted to voltage high
- Actuator winding shorted (overcurrent) medium
- Corrosion or moisture in the connector medium
- Output driver in the engine module faulty low
Symptoms
- Check engine light (depending on the maker)
- Loss of power in part of the rev range
- Actuator does not click when switching
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P0665
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.