OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0663

Intake Manifold Tuning Valve Control Circuit/Open Bank 2

The intake manifold tuning valve switches the manifold length or plenum connection with engine speed (more torque low, more power high); it is not the runner or swirl flap (IMRC, P2004 ff). P0663 means the control circuit of the bank 2 valve is open. Bank 2 codes require a V-engine manifold with two separately switched valves; many V engines use a single central valve between the plenums, and no manufacturer document available to us uses this code, so the description follows bank 1. At GM the bank 1 equivalent (P0660) flags 200 kΩ or more with the driver off and lights the lamp after two trips; Ford runs bank-specific checks only for its runner control flaps (IMRC, P2005/P2011) and treats the tuning valve without the lamp. The valve stays in its rest position, with a power loss around the switch-over speed.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 63

Possible causes

  • Actuator connector loose, corroded or spread high
  • Bank 2 actuator coil open high
  • Broken wire in the harness medium
  • Output driver in the engine module faulty low

Symptoms

  • Check engine light (depending on the maker)
  • Loss of power in part of the rev range
  • Actuator does not click when switching

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0663

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication