OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0662

Intake Manifold Tuning Valve Control Circuit High Bank 1

The intake manifold tuning valve switches the manifold length or plenum connection with engine speed (more torque low, more power high); it is not the runner or swirl flap (IMRC, P2004 ff). P0662 means a short to voltage in the bank 1 control circuit: with the driver on, the low-side line should be pulled to ground, but the voltage stays high (0.5 Ω or less to positive); the driver protects itself and the valve is not actuated. GM's engines with this valve (low-side driver) check with ignition voltage of at least 11 V and the engine above 400 rpm and set the code after 40 of 50 samples (about 0.6 s), with the check engine light after two trips. Ford does not use P0662. The valve stays in its rest position, with a power loss around the switch-over speed.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 62

Possible causes

  • Control wire shorted to battery or supply voltage (harness) high
  • Actuator winding shorted (very low resistance, overcurrent) medium
  • Moisture or corrosion in the connector between supply and control pin medium
  • Output driver in the engine module faulty low

Symptoms

  • Check engine light (depending on the maker)
  • Loss of power in part of the rev range
  • Actuator does not click when switching

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0662

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication