OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0661

Intake Manifold Tuning Valve Control Circuit Low Bank 1

The intake manifold tuning valve switches the manifold length or plenum connection with engine speed (more torque low, more power high); it is not the runner or swirl flap (IMRC, P2004 ff). P0661 means the bank 1 control circuit voltage is too low with the driver off – a short to ground (0.5 Ω or less), which bypasses the driver and keeps the valve energised; GM also includes an open circuit (200 kΩ or more) here, so P0660 may set alongside. GM's engines with this valve (low-side driver) check with ignition voltage of at least 11 V and the engine above 400 rpm and set the code after 40 of 50 samples (about 0.6 s), with the check engine light after two trips. Ford does not use P0661.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 61

Possible causes

  • Low-side control wire shorted to ground by chafing on engine or manifold high
  • Actuator shorted internally to housing or ground medium
  • Open circuit (connector, coil) – included under P0661 at GM medium
  • Output driver in the engine module faulty low

Symptoms

  • Check engine light after two trips (GM)
  • Torque or power gap in one rev band
  • Possibly blown fuse, further codes of the same supply circuit

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0661

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication