OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0659

Actuator Supply Voltage A Circuit High

Actuator supply A is a high-side switch feeding several actuators together; its use differs by maker (Ford transmission solenoids, GM shared high-side driver, GM Europe 2.0 CDTI internal 5 V supply). P0659 means a short to voltage on the supply output, checked with the driver off – the output should then be dead (GM: 0.5 Ω or less to the supply, 20 of 25 samples; lamp after two trips in 2017–18, none in 2016). The driver can then no longer switch the actuators off; GM's transmission modules block their solenoid diagnostics while P0658/P0659 are active, and limp mode follows. On GM Europe's 2.0 CDTI it means the internal 5 V supply is too high, without MIL – the engine module is replaced.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 59

Possible causes

  • Actuator supply wire shorted to battery or ignition voltage high
  • Harness chafed against a 12 V line medium
  • Module (driver shorted; internal on the Saab diesel) medium
  • External voltage fed back through a faulty actuator low

Symptoms

  • Check engine light (GM from 2017)
  • Transmission or actuator limp mode
  • Actuators cannot be switched off
  • Follow-up codes

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0659

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication