P0656
Fuel Level Output Circuit
The engine module switches this hard-wired output with its own driver and checks the circuit electrically (open, short to ground or voltage) – it cannot see whether the lamp lights; on CAN-based cars such faults appear as U codes. Where the engine module reads the fuel level sender itself – it needs the level for the evaporative leak test – it passes the level on to the fuel gauge. GM Europe's 2010 Saab 9-5 reads two senders (0.5–3.5 V), calculates the level in percent and sends it over CAN via the body module to the instrument cluster; there a failure would be a U code. P0656 reports a fault on a hard-wired level output. No manufacturer document available to us uses this code; the description follows CARB and the component. The gauge then reads empty, full or jumps and the low fuel warning is wrong; engine and evaporative test are not affected. Sender input faults are P0460–P0464.
Possible causes
- Wire or connector between module and instrument cluster open or shorted high
- Instrument cluster (fuel gauge input) faulty medium
- Output driver in the module faulty low
- Fuel level sender fault as root cause low
Symptoms
- Fuel gauge reads empty, full or jumps
- Low fuel warning wrong
- Range display wrong
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0656
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.