OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0655

Engine Hot Lamp Output Control Circuit

The engine module switches this hard-wired output with its own driver and checks the circuit electrically (open, short to ground or voltage) – it cannot see whether the lamp lights; on CAN-based cars such faults appear as U codes. P0655 concerns the engine hot or coolant warning lamp that the engine module switches by wire from the coolant temperature signal. CARB links overtemperature protection strategies to this lamp: a protective reaction that only starts after the hot lamp lights needs no MIL. No manufacturer document available to us uses this code; the description follows CARB and the component. If the circuit fails, the driver may not be warned of overheating – check it promptly even though the check engine light usually stays off. Actual overheating is P0217; the coolant sensor circuit is P0117/P0118.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 55

Possible causes

  • Wire or connector between module and receiver open, corroded or shorted high
  • Bulb/LED or instrument cluster faulty medium
  • Lamp supply missing (fuse) medium
  • Output driver in the module faulty low

Symptoms

  • Temperature warning lamp does not light at bulb check or when overheating
  • Warning lamp stays on without overheating
  • Code stored, check engine light depending on the maker

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0655

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication