OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0654

Engine RPM Output Circuit/Open

The engine module switches this hard-wired output with its own driver and checks the circuit electrically (open, short to ground or voltage) – it cannot see whether the lamp lights; on CAN-based cars such faults appear as U codes. P0654 concerns the engine speed output: the module turns the crankshaft signal into a cleaned-up square wave for the tachometer and other modules – Saab's 1999 9-3, for example, sends two pulses per revolution, about 30 Hz at idle. P0654 reports an open circuit or other fault on this output. Saab's EDC16 diesels use P0654 differently (a sensor supply group). No manufacturer document available to us uses this code; the description follows CARB and the component. The tachometer then reads zero or jumps; devices using the signal may fail, while the engine itself runs normally because the crankshaft input is intact.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 54

Possible causes

  • Wire between module and tachometer or receiver open, connector corroded high
  • Output wire shorted medium
  • Instrument cluster or receiving module faulty (input stage) medium
  • Output driver in the module faulty low

Symptoms

  • Tachometer reads zero or jumps
  • Functions using the speed signal disturbed (accessories, cruise control, shift indicator)
  • Check engine light depending on the maker

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0654

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication