P0652
Sensor Reference Voltage B Circuit Low
The engine module feeds several sensors (camshaft, pedal, pressure sensors) from separate regulated 5 V reference circuits; 'B' is circuit 2. A short at one sensor pulls the whole reference down, so every sensor on it reports at once – unplug them one by one until the reference returns to 4.8–5.2 V. P0652 means reference B is too low – usually the 5 V line or a connected sensor is shorted to ground. GM's 6.6 L Duramax LB7/LLY (2004–05) sets it below 4.7 V for 2 s; GM Europe's 2.0 L turbo after 1 s or 10 s cumulative, each with the lamp in the first trip. Newer GM engines report it under the collective code P0651, and Ford does not use P0652. All sensors on the circuit then read low, with matching codes, limp mode and possibly starting problems.
Possible causes
- 5 V reference wire shorted to ground (chafing) high
- Sensor on the reference circuit shorted internally high
- Moisture or corrosion in a connector medium
- Module low
Symptoms
- Check engine light
- Several 'low' sensor codes at once
- Limp mode or reduced power
- Starting problems
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0652
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- saabwisonline.com/9-5-9650/2011/2-engine/engine-management-and-fuel-system-2-0-l-petrol/fault-diagnosis-diagnostic-trouble-codes/dtc-p0641-p0643-p0651-p0653-or-p0697-p0699-ecm
- gsi.ext.gm.com/gmspo/mode6/pdf/2004/2004file9.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2005/2005file9.pdf