OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P064E

Internal Control Module O2 Sensor Processor Performance Bank 2

Wide-band oxygen sensors need a pump current control; inside the engine module a dedicated chip (ASIC, for example Bosch's CJ125 family) regulates it, measures lambda, diagnoses sensor wiring and heater, and talks to the main processor via SPI. P064E is the bank 2 counterpart of P064D and only occurs on V and boxer engines with two sensors before the catalysts. Ford sets it when the SPI communication with the bank 2 chip fails (10 s; an internal chip fault adds Ford's P1647); GM uses the same error counters as for bank 1 (128 of 160 samples, lamp after two trips). Fuel control on bank 2 then runs open loop, with higher consumption and emissions. Check the bank 2 sensor 1 wiring and sensor first; if they are fine, the engine module is the likely cause.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 4E

Possible causes

  • Engine module (lambda chip bank 2) faulty high
  • Wiring or connector fault of the bank 2 sensor 1 medium
  • Bank 2 wide-band sensor faulty medium
  • Voltage dips or software low

Symptoms

  • Check engine light
  • Higher fuel consumption, rough running
  • Failed emissions test
  • Codes for the bank 2 sensor 1 wide-band sensor

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P064E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication