OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P064D

Internal Control Module O2 Sensor Processor Performance Bank 1

Wide-band oxygen sensors need a pump current control; inside the engine module a dedicated chip (ASIC, for example Bosch's CJ125 family) regulates it, measures lambda, diagnoses sensor wiring and heater, and talks to the main processor via SPI. P064D means this chip for bank 1 sensor 1 does not work correctly or its messages are invalid. Ford validates the SPI communication continuously and sets P064D/P064E after 10 s at 11–18 V with the sensor heater working; an internal chip fault adds Ford's P1646/P1647. GM (wide-band engines such as the 3.0 L twin turbo, 2018–2025) evaluates two error counters from the chip and sets the code at 128 of 160 samples (about 4 s), more than 20 s after start-up, with the lamp after two trips. Fuel control then runs open loop and oxygen sensor monitors are disabled – fuel consumption and emissions rise. Faults in the sensor or wiring can also push the chip into an invalid state.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 4D

Possible causes

  • Engine module (lambda chip) faulty high
  • Wiring or sensor fault pushing the chip into an invalid state (short to battery voltage, water in connector) medium
  • Faulty wide-band sensor (e.g. heater-to-signal short) medium
  • Voltage dips or software low

Symptoms

  • Check engine light
  • Higher fuel consumption, rough running (open loop)
  • Failed emissions test
  • Codes for the bank 1 sensor 1 wide-band sensor

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P064D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication