OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P064C

Glow Plug Control Module 1

On diesels a glow plug control module switches the glow plugs (at Ford also the DEF heaters) with semiconductor switches, diagnoses itself and reports to the engine module. P064C means this module reports an internal fault. GM's 2017–18 Duramax checks for a switch that is commanded on but delivers less than 3.2 A and 0 V at the plug (3.5 s), ROM, RAM and EEPROM checksums, the charge pump of the high-side drivers and reverse polarity; the LML (2011–16) used under 6.6 A for 75 % of 4 s; lamp after two trips. Ford's 2023 diesels flag drivers that do not switch or overheat, a RAM checksum error, supply below 6.5 or above 16.5 V and module temperature above 125 °C, within about 1 s. The glow system then fails partly or completely: hard cold starts, white smoke and higher cold-start emissions.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 4C

Possible causes

  • Glow plug module faulty internally (switches, memory) high
  • Insufficient supply or ground (battery, corrosion, main fuse) medium
  • Short in a glow plug or wire overloading a driver medium
  • Moisture or corrosion in the connector of the engine-mounted module low

Symptoms

  • Check engine and glow plug lamp
  • Hard cold start, long cranking in cold weather
  • White smoke and rough running after a cold start
  • Glow plug circuit codes as well

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P064C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication