OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P064A

Fuel Pump Control Module A

Demand-controlled fuel systems drive the pump through a separate pump control module; the engine module sets the target and reads its status back. P064A means this module reports an internal fault. Ford petrol engines encode the status as a duty cycle on a monitor line – 30 % (±4 %) means internal driver fault, 20 % invalid data (P025B), no signal U0109 – and set the code after 2–5 s; Ford's 2023 diesel checks the period of the monitor signal (0–1.2 s, 0.5 s). GM's pump module sets P064A when its output stage exceeds 150 °C (3 of 15 samples), with the lamp after two trips; Ford petrol stores it without the lamp. Pump output may be reduced or switched off, so low fuel pressure, stalling or a no-start can follow. A stiff, worn pump drawing high current can overheat the module.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 4A

Possible causes

  • Pump control module faulty internally (output stage, electronics) high
  • Output stage overheating from a stiff or worn pump or poor module cooling medium
  • Supply or ground fault or corrosion at the module (often on frame or tank) medium
  • Disturbed monitor line, so a wrong duty cycle is read low

Symptoms

  • Check engine light (GM) or stored code only (Ford petrol)
  • Hard start, stumbling or lack of power from low fuel pressure
  • Stalling or no start if the pump is switched off
  • Fuel pressure codes as well (e.g. P0087)

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P064A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication