P0648
Immobilizer Lamp Control Circuit
The engine module switches this hard-wired output with its own driver and checks the circuit electrically (open, short to ground or voltage) – it cannot see whether the lamp lights; on CAN-based cars such faults appear as U codes. P0648 concerns the immobiliser or security lamp where the engine module drives it directly by wire – on GM and Saab systems this lamp shows the immobiliser learn mode and faults. No manufacturer document available to us uses this code; the description follows CARB and the component. The lamp then does not show the immobiliser status, or shows it permanently; the immobiliser itself keeps working, because start authorisation is separate (key faults are P0513/P0633). The immobiliser is not an emission component, so no check engine light is expected.
Possible causes
- Wire or connector between module and receiver open, corroded or shorted high
- Bulb/LED or instrument cluster faulty medium
- Instrument cluster (board, connector) faulty medium
- Output driver in the module faulty low
Symptoms
- Immobiliser lamp off, permanently on or flashing wrongly
- Code stored
- Engine start normally not affected
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0648
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.