OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0645

A/C Clutch Relay Control Circuit

The engine module switches the A/C compressor clutch relay through a low-side driver once the climate control requests cooling. P0645 is the general circuit fault of the relay coil control, usually an open circuit. GM Europe's 2011 Saab 9-5 sets P0645/P0646 for an open or short to ground and P0647 for a short to voltage, with the engine running and A/C requested; Ford's commercial trucks report it without the check engine light. Older Saab diesels (Bosch EDC16/PSG16) use a different assignment (P0645 short to voltage, 0.6 s). GM found a no-start with P0645 on the 2002–04 Alero/Grand Am 3.4 L because a shorted compressor clutch coil blew a fuse shared with the engine control; Ford traced warm air with P0645 on the 2020–23 Explorer to spread terminals at the body module. The compressor then does not engage or runs constantly.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 45

Possible causes

  • A/C clutch relay faulty (coil open) high
  • Control wire or connector open, terminals spread high
  • Relay or clutch supply fuse blown (e.g. shorted clutch coil) medium
  • Output driver in the module faulty low

Symptoms

  • A/C not cooling (compressor does not engage)
  • Compressor runs constantly
  • Check engine light usually off, code stored only
  • Rarely no start if a shared fuse has blown (GM 3.4 L)

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0645

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication