P0644
Driver Display Serial Communication Circuit
P0644 concerns a dedicated serial line on which the engine module sends values or warnings to a driver display or information display – not the general vehicle CAN bus. The module reports missing or invalid communication on that line (open, short, display not answering); CARB requires digital outputs to be checked for communication faults. GM Europe's 2010 Saab, for example, passes engine data such as fuel level over CAN to the body module and on to the instrument unit and information display – where such data runs on the bus, a failure is reported as a U code (e.g. U0155) instead. No manufacturer document available to us uses this code; the description follows CARB and the component. Displays then show missing, frozen or jumping information; the engine runs normally.
Possible causes
- Wire or connector between module and receiver open, corroded or shorted high
- Display or instrument cluster faulty or without supply (fuse, ground) medium
- Low system voltage during cranking low
- Output driver in the module faulty low
Symptoms
- Warning message or lamp (depending on the maker)
- Information in the driver display missing, frozen or jumping
- Display stays dark
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0644
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.