P0640
Intake Air Heater Control Circuit
Some diesels (for example GM's 6.6 L Duramax LML and the Cummins in Ram trucks) warm the intake air with a heater grid switched by a relay or semiconductor switch. P0640 reports a fault in its control circuit. GM's LML glow plug module expects a digital feedback from the heater while it is commanded on; if it is missing for 2 s (75 % of 4 s), the code sets and the lamp follows after two trips. Current, voltage and temperature faults run under GM's own codes P154A–P154D. CARB requires intake air heaters to be checked for response, current and voltage drop. The result is poor cold starts, white smoke and rough running after a cold start; a relay stuck on drains the battery – Ram recalled 2021 trucks because a shorted heater relay could overheat. Ford's 2023 diesel does not use P0640.
Possible causes
- Heater relay or switching module faulty high
- Control wire or connector open or corroded medium
- Heater grid burnt out or shorted to ground medium
- Heater main cable or fuse loose or faulty medium
- Glow plug or engine module faulty low
Symptoms
- Check engine light
- Poor cold start in low temperatures
- White smoke, rough running after cold start
- Flat battery if the relay sticks
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0640
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.