OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P063E

Auto Configuration Throttle Input Not Present Bank 1

Some modules configure themselves at start-up by detecting which inputs are present. P063E means the module expects a throttle position input for bank 1 but does not detect it. Unlike circuit codes such as P0122/P0123 or P2135, which judge a present but faulty signal, this says the input was not found for the configuration. No manufacturer document or patent available to us describes this check; the explanation is derived from the J2012 wording. CARB requires input components to be checked for circuit continuity and plausibility, and modules with several variants to detect a wrong one. Possible causes are an unplugged throttle body or open wiring, or software meant for a different vehicle. Without a throttle signal an electronic throttle runs in limp mode.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 3E

Possible causes

  • Throttle sensor or unit not connected, connector or wire open medium
  • Wrong module software or variant for the vehicle (module from another model) medium
  • Faulty throttle unit low
  • Internal module fault low

Symptoms

  • Check engine light
  • Limp mode, reduced power
  • Rough idle, poor throttle response
  • Additional throttle circuit codes

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P063E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication