P063C
Generator Voltage Sense Circuit A Low
Some charging systems measure the actual battery or alternator voltage through a separate sense line (regulator terminal S or an input of the module) to compensate voltage drops in the charging cable; without it the system reports a charging fault. No manufacturer document available to us uses P063A–P063D, so these descriptions follow the circuit principle and CARB, under which a charging-system input needs the check engine light only if it affects emissions or other diagnostics. P063C means the sense voltage is below its limit or below battery voltage – open circuit, short to ground or high resistance; the regulator may then overcharge or fall back to a fixed target.
Possible causes
- Sense wire, fuse or connector between battery and alternator or module open or corroded high
- Alternator or regulator faulty medium
- Contact resistance at battery terminals or grounds medium
- Battery faulty low
Symptoms
- Battery warning lamp on
- Charging voltage too high or too low (flat or overcharged battery)
- Flickering lights
- Further voltage codes (P0562/P0563)
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P063C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.