OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0637

Power Steering Control Circuit High

P0635–P0637 concern the control or signal circuit between engine module and power steering – depending on the maker the drive of an electro-hydraulic pump or the steering load signal the engine module uses to raise idle. CARB requires power steering components to be monitored only if another diagnostic uses them, so these codes are rare and maker-specific. Mercedes-Benz stores P0635 in the electric steering module itself (no assist after start, software update); no engine module table available to us uses P0635–P0637. P0637 means the voltage in this circuit is too high – a short to battery voltage, or the driver or steering module reports a high state although 'off' was commanded; an electro-hydraulic pump may then keep running. No manufacturer threshold is published.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 37

Possible causes

  • Control or signal wire shorted to battery voltage high
  • Steering module or pump module faulty internally medium
  • Overvoltage from the alternator regulator low
  • Engine module faulty low

Symptoms

  • Power steering warning
  • Heavy steering or pump running constantly
  • Check engine light possible

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0637

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication