OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0635

Power Steering Control Circuit

P0635–P0637 concern the control or signal circuit between engine module and power steering – depending on the maker the drive of an electro-hydraulic pump or the steering load signal the engine module uses to raise idle. CARB requires power steering components to be monitored only if another diagnostic uses them, so these codes are rare and maker-specific. Mercedes-Benz stores P0635 in the electric steering module itself (no assist after start, software update); no engine module table available to us uses P0635–P0637. P0635 is the general or open-circuit code; output components must be checked for circuit faults, but separate low/high codes (P0636/P0637) are not mandatory. Steering assist may fail or be reduced; without the load signal idle can sag at full lock. The power steering pressure switch family is P0550–P0554.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 35

Possible causes

  • Wire or connector between engine module and steering module or pump open or corroded high
  • Software or calibration fault in the steering module (Mercedes) medium
  • Steering module or electro-hydraulic pump faulty medium
  • Undervoltage from weak battery, alternator or poor ground medium
  • Engine module faulty low

Symptoms

  • Power steering warning, heavy steering
  • Check engine light (depending on the maker)
  • Idle drops when steering
  • Fault possibly only after engine start

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0635

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication