OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P062F

Internal Control Module EEPROM Error

Learned values, adaptations, counters and configuration are saved to non-volatile memory (EEPROM or flash-emulated NVM) when the module shuts down. P062F means this memory failed a check: GM and GM Europe test at start-up whether the last write at shutdown completed, GM's 6.6 L diesel checks a checksum per data block and whether sectors can be erased, Ford's diesel reports read, write or erase errors (5 s). Lamp behaviour varies: GM petrol engine modules after two trips, the Duramax 2014 and Saab 2.0 L turbo in the first trip, GM transmission modules and GM Europe's 1.6 L turbo without it. Most often the shutdown was interrupted – battery disconnected, voltage dip, main relay dropping out too early. Learned values are lost and relearned. The code also appears in transmission and other modules.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 2F

Possible causes

  • Shutdown interrupted (battery disconnected, voltage dip, main relay drops out too early) high
  • Weak battery, poor ground or supply at the module medium
  • Software fault or incomplete programming medium
  • Memory defect in the module (write cycles, ageing) low

Symptoms

  • Check engine or service lamp (depending on the maker, sometimes after two trips)
  • Learned values lost: rough idle or harsh shifts until relearned
  • Often no driveability symptoms

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P062F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication