OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P062D

Fuel Injector Driver Circuit Performance Bank 1

Direct-injection injectors (petrol and common-rail diesel) need a high boost voltage generated in the module to open fast; the module then holds them with pulsed battery voltage. P062D monitors this boost voltage or the shared injector supply of bank 1. GM's 2018 Duramax sets it when the internal boost voltage is above 75 V or below about 52 V, the supply line to the injectors is open or the module has an internal fault, in 14 of 20 samples at 6.25 ms, with the lamp in the first trip (2025: above 60 V or below 40 V). Ford's petrol direct injection flags it when the opening current is not reached in time (10 s, no cylinder named), Ford's diesel when the driver chip reports a loss of high voltage (0.5 s). Injectors then open late or not at all: misfires, rough running, loss of power or no start. GM uses only P062D, also on V8s. Single injector circuits are P0201 ff.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 2D

Possible causes

  • Short in an injector high-side wire or injector collapsing the boost voltage high
  • Module internal (boost converter, driver chip) medium
  • System undervoltage or poor ground medium
  • Harness or injector connector (moisture, oil) medium

Symptoms

  • Check engine light (GM in the first trip)
  • Misfires, rough running, stumbling
  • Loss of power or limp mode
  • Hard start or no start

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P062D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication