OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P062B

Internal Control Module Fuel Injector Control Performance

P062B monitors the injector driver stage inside the engine module. On direct injection engines a separate driver chip generates the boost voltage for opening the injectors and is configured by the main processor via SPI; GM checks initialisation, boost voltage (petrol: 90 V or more or 40 V or less), self-test, data download and communication, and sets the code in the first trip – while it is active, single injector circuit codes are suppressed. Saab's 2.0 L turbo also counts a short to ground in an injector circuit (10 s, two trips). Ford's diesel uses it as a plausibility check of the injection command (post injection, energising over 200 µs during overrun), Ford petrol engines only with cylinder deactivation. Chrysler's 3.0 L EcoDiesel was fixed by software. Misfires, loss of power or stalling follow.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 2B

Possible causes

  • Short to ground on an injector high-voltage or control wire, or a faulty injector medium
  • Engine module software or calibration fault (update available) medium
  • Undervoltage or supply problem (battery, main relay) medium
  • Faulty driver chip in the engine module medium

Symptoms

  • Check engine light (GM in the first trip)
  • Stumbling, misfires, loss of power
  • Starting problems or stalling
  • Other injector codes are not reported while P062B is active (GM)

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P062B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication