OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0628

Fuel Pump A Control Circuit Low

What 'fuel pump A control circuit' means differs by maker: at GM petrol engines it is the control line from the engine module to the fuel pump relay (high-side driver), at GM's LML diesel the lift pump, at Ford petrol engines with a pump driver module the secondary circuit from that module to the pump (reported as a duty cycle on a monitor line), and at Ford's 6.7 L diesel (F-650/750) the high or low side of the pump relay. P0628 means a short to ground: GM detects 0.5 Ω or less to ground with the driver on (8 of 10 samples at 250 ms; two trips in 2018, first trip in 2025); the driver then shuts off, the relay does not pull in and the pump stops. Ford's 6.7 L diesel reports a short to ground on the high side of the pump relay within 0.2 s. Ford petrol engines do not use P0628. A blown fuse is a frequent companion.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 28

Possible causes

  • Control wire to relay or pump shorted to ground (chafing) high
  • Relay coil shorted medium
  • Pump or pump module shorted internally (Ford high side) medium
  • Driver in the engine module faulty low

Symptoms

  • No start or stalling
  • Pump does not run
  • Blown fuse
  • Check engine light on

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0628

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication