OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0627

Fuel Pump A Control Circuit/Open

What 'fuel pump A control circuit' means differs by maker: at GM petrol engines it is the control line from the engine module to the fuel pump relay (high-side driver), at GM's LML diesel the lift pump, at Ford petrol engines with a pump driver module the secondary circuit from that module to the pump (reported as a duty cycle on a monitor line), and at Ford's 6.7 L diesel (F-650/750) the high or low side of the pump relay. P0627 is the open or general circuit fault. GM measures with the relay driver on and sets the code at 200 kΩ or more after 8 of 10 samples at 250 ms – after two trips in 2018, in the first trip in 2025; some modules also set P0629. Ford's petrol pump module reports an open, short or overheating in its secondary circuit (2012: 80 % duty cycle, 2–5 s), Ford's 6.7 L diesel an open relay side within 0.2 s. Without the pump the engine does not start or stalls.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 27

Possible causes

  • Fuel pump relay or pump driver module faulty high
  • Wire or connector to relay or pump open or corroded (tank, underbody) high
  • Fuel pump itself (winding open, overheated) medium
  • Fuse or ground point medium
  • Driver in the engine module faulty low

Symptoms

  • Engine does not start or stalls
  • Lack of power or stumbling under load
  • Pump not audible with ignition on
  • Check engine light on

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0627

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication